Splicing is a common raw material for house decoration, and is often applied to walls and ceilings. How to install splicing? PVC panel manufacturers take everyone to master it.
The key to the installation steps of the ceiling PVC panel are: mark the line, install the main keel boom, then install the main keel and the secondary keel, then install the side aluminum strips and install the aluminum PVC panel ceiling, and finally install the lighting fixtures and ventilation holes. The actual regulations are as follows:
1. Pay-off
According to the design elevation line of the building, the vertical space vector is used to reach the elevation of the roof construction, the cast-in-place slab is filled with the line of the keel, and the design elevation of the roof is drawn on the wall in a straight line.
2. Install the main keel boom
Which PVC panel manufacturer is better
After the design elevation line of the canopy and the line of the main keel are played, the design elevation of the lower head of the boom is clarified. According to the main keel and the suspension interval, fix the end of the boom without anchor bolts with expansion screws. Under the concrete floor; the suspenders use 6m building steel bars (8mm galvanized flat steel).
3. Install the main keel
Add skills to the hanger nut, put a whisper on the main keel to hang the hanger in advance, put the assembled hanger's main keel into the opposite hanger anchor bolt according to the position of the division line, tighten the nut, and connect The main keel is equipped with connecting parts, the height of the hanging wire is adjusted to be straight, the additional main keel is installed on the side of the hole, the setting and the connection are fixed.
